Migration tasks
Issue 2.1 June 2006 563
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: Customers who currently use the Audix feature on the S8100 must purchase a
separate Audix system. The TN795 or the TN2314 Processor circuit pack that
contains the Audix feature is replaced with a TN2312BP Internet Protocol Server
Interface (IPSI) circuit pack that does not contain the Audix feature. You must
return the existing processor circuit pack to Avaya.
Note:
Note: Customers also must add an ED-1E568-70G1 DEFINITY Audix Slim board and a
TN2501AP Voice Announcement over LAN (VAL) circuit pack for
announcements.
Changing the control cabinet to a port network
To change the control cabinet to a port network, you must:
● Replace the TN795 or TN2314 Processor circuit pack with a TN2312BP Internal Protocol
Server Interface (IPSI) circuit pack.
● Connect a CAT5 straight-through cable from the IPSI to the media server through the
network of the customer.
Note:
Note: If you replace a TN795 Processor circuit pack, you might not need the TN744D/E
Call Classifier-Detector circuit pack. The TN2312BP IPSI circuit pack has call
classifier functionality. However, increased voice and data traffic can require the
TN744D/E Call Classifier-Detector circuit pack.
Note:
Note: If you have a TN799C or earlier CLAN circuit pack, you must replace the TN799
circuit pack with a TN799DP CLAN circuit pack.
To Next Page
Loading...
