Migrating translations
Issue 2.1 June 2006 727
Installing the translations
To install the translations:
1. Type reset system 4. Press Enter.
2. Return the STS-supplied PCMCIA flash card to Avaya.
To add the IPSI translations before saving translations, go to Adding IPSI translations to
Communication Manager on page 727.
Adding IPSI translations to Communication Manager
To add IPSI translations to Communication Manager:
1. Type add ipserver-interface 1. Press Enter to add the IPSI circuit pack information.
2. If you use static addressing, in the Host field, type the IP address for the IPSI that is in the
port network listed in the Location field.
3. Verify that the IP Control? field is set to y.
4. Verify that all the other fields are populated.
5. Press Enter to put the changes into effect.
6. Repeat Steps 1 through 5 for each IPSI.
Setting IPSI duplication (high-reliability critical-reliability only)
To set IPSI duplication:
1. Type change system-parameters duplication. Press Enter.
2. Set the Enable Operation of IPSI Duplication field to y.
3. Press Enter to put the changes into effect.
Adding IPSI information
To add IPSI information:
1. Type add ipserver-interface PNnumber where PNnumber is the port network
number. Press Enter.
2. When you use static addressing, in the Host field, type in the IP address for the IPSI in the
port network that is listed in the Location field.
3. Verify that all the other fields are populated.
To Next Page
Loading...
