Checklist
Issue 2.1 June 2006 1179
● Input to server and Output to server is selected for filesync, port 21874/tcp
● Input to server and Output to server is selected for h323gatestat, port 1719/udp
● Input to server and Output to server is selected for h323hostcall, port 1720/tcp
If any of the defaults are not set correctly, contact your sales representative.
5. Click the Standard Service button to return to the first Firewall page, then click Submit.
Connect the new S8500 LSP to the LAN/WAN
Cable the appropriate Ethernet port on the LSP to the customer LAN.
Verify connectivity of the LSP to the customer LAN.
Reset the S8500 LSP
Use the following commands to notify all processes of the new parameters:
Note:
Note: When you access the SAT screen prior to doing a reset, the screen might
indicate a license mismatch. This temporary mismatch is normal and is resolved
after the reset.
1. From the SAT command line, enter reset system 4.
The system resets. In addition, the system registers with the new primary controller and
receives the translations from the primary controller.
Verify that the primary controller identifies the new LSP and has
sent the translations
To verify that the S8500 LSP has registered with the primary controller and has received the
translations, perform the following steps:
1. Wait several minutes for the reset to finish.
2. On the new primary controller, use the SAT command list survivable-processor
to verify that the LSP server registers and translations are updated.
If the LSP has registered, the Service State? field shows in-service and the Translations
Updated field shows the time and date.
To Next Page
Loading...
