Converting some or all ATM port networks to IP-PNC
1134 Upgrading, Migrating, and Converting Media Servers and Gateways
4. Enter change system-parameters duplication to open the duplication screen.
5. In the Enable Operation of PNC Duplication? field, enter n and press Submit.
Removing fiber-related administration
Before the IP connections can be used, you must remove the fiber administration for each PN
that is being converted to IP-PNC.
Complete the following steps at the SAT to busyout and remove the fiber links for each PN
being converted to IP-PNC:
Tip:
Tip: To view the fiber link numbers and their endpoints, enter list fiber-link.
1. Enter busyout fiber-link n, where n is the link number for the fiber connection.
2. Enter remove fiber-link n
3. Repeat steps 1
and 2 for each IP-PNC PN.
Enabling PNC duplication, if necessary
If the final configuration is a mixture of fiber-PNC and IP-PNC PNs and if the fiber- connect
portion is duplicated, you must enable PNC duplication.
To enable PNC duplication at the SAT:
1. Enter change system duplication to open the PNC Duplication screen.
2. Enter y in the Enable Operation of PNC Duplication? field and press Submit.
Removing fiber-related hardware
Complete these steps for each PN that you are converting to IP-PNC:
1. Remove the fiber cables that connect the EI circuit packs, TN570, and the ATM-EI circuit
packs, TN2305B or TN2306B, in the PNs.
2. Remove the DS1 cable connecting the ATM switch to the sync splitter, if present.
3. Remove the TN2305B or TN2306B ATM-EI circuit packs from the PN cabinets, carriers, or
gateways.
4. Remove the tone-clock circuit packs, TN2182, from the PN cabinets, carriers, or gateways.
To Next Page
Loading...
