Migrating translations
Issue 2.1 June 2006 767
Connecting to the active media server
Note:
Note: If the PCMCIA memory card currently is plugged in to the bottom slot on the
active media server, remove the card. You need the bottom slot to plug in the
MOST tool.
To connect to the active media server:
1. Click Start > Run > Command to open a DOS Command window.
2. Perform one of the following actions:
● If you are connected to the Services port (2):
a. Type telnet 192.11.13.6 and press Enter.
b. At the login prompt, log in as craft or dadmin.
● If you are connected through the customer network:
a. Type telnet ipaddress, where ipaddress is the active media server IP address
and press Enter.
b. At the login prompt, log in as craft or dadmin.
Copying translation files from the MO disk to the active
S8700-Series Media Server
To copy translation files from the MO disk to the active media server:
1. Type stop -acf. Press Enter to stop Communication Manager call processing.
2. Type sudo readmo -e. Press Enter to enable MO read.
3. Turn on the MO drive. Use the power switch on the back of the drive. For the media servers,
see Magneto optical drive connection to media servers
on page 769.
4. S8710: Insert the MOST Tool USB cable into a USB port on the back of the media server.
5. Insert the optical disk into the external MO drive.
6. Type sudo mo -1. Press Enter to list the contents of the MO disk. Note the file sizes of
Translation and TranslationA.
Note:
Note: The next step copies the translation files from the MO disk to /etc/opt/defty on the
media server hard disk.
To Next Page
Loading...
