Avaya S8100 Series - Verifying IPSI connectivity; Enabling control of the IPSI

Post-migration administration
Issue 2.1 June 2006 697
2. Verify that the ISPI circuit pack(s) are translated.
The State of Health - C P E G column shows 0.0.0.0 for each healthy IPSI. If a "1" shows
in any position, you must troubleshoot the problem.
Tip:
Tip: The pattern 0.1.1.0 usually means that a cabinet type is administered
incorrectly or a connectivity problem exists, such as an incorrectly terminated
cable.
Verifying IPSI connectivity
To verify IPSI connectivity:
1. Under Diagnostics, click Ping.
2. Under Endpoints to Ping, select IPSIs with cab number (1–99) ___ carrier number ___.
3. Type the correct cabinet and carrier numbers in the text boxes.
4. Click Execute Ping.
5. Verify that the endpoints respond correctly.
Enabling control of the IPSI
To enable control of the IPSI:
Note:
Note: Ensure that the IPSI has the same, current firmware.
!
CAUTION:
CAUTION: This procedure allows the media server to take control of the IPSI-controlled port
network(s). Failure to complete the steps correctly can result in no connection to
the network.
1. Type change system-parameters ipserver-interface. Press Enter.
The system displays IP Server Interface (IPSI) System Parameters window.
2. Set the IPSI Control of Port Networks: field to enabled
3. Press Enter to effect the change.
4. Type save translation. Press Enter.
The media server now controls all the port networks.