Post-migration administration
Issue 2.1 June 2006 601
Figure 29: Connecting directly to the IPSI
Note:
Note: Ensure that you have the IPSI password before you continue.
Clearing the ARP cache on the laptop computer
You might need to clear the Address Resolution Protocol (ARP) cache before you enter a new
IP address. This need depends on the operating system on your laptop computer. If you enter
an IP address and your computer cannot connect, you might need to clear the cache.
To clear the ARP cache on the laptop:
1. Click Start > Run to open the Run dialog box.
2. To open an MS-DOS command line window, type command. Press Enter.
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
● The command line prompt displays when the cache is cleared.
● The message The specified entry was not found appears when the specified IP
address does not currently appear in the ARP cache.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 cross-over cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
