Avaya S8100 Series - Selecting media server type; Configuring the network parameters (optional)

Upgrade tasks (first media server)
Issue 2.1 June 2006 169
Selecting media server type
You must select the media server type.
1. Under Server Configuration click Configure Server to open the Select server type page
of the Configure Server process. If you selected the server type earlier, you do not see this
screen.
2. Select the appropriate server type and click Continue.
Configuring the network parameters (optional)
Note:
Note: If you backed up the system files to the flashcard, do not perform this procedure.
Continue with Installing postupgrade service pack, if any, on media server
on
page 171.
If you backed the system files up to the customer network, you must readminister
the Ethernet port that connects to the customer network. You must have the
following information for the two media servers and the active server:
- Host name
- IP address
- Subnet mask
- Default gateway
In addition, you need the IP address for the Ethernet port connecting to the customer
network.