Migration tasks
Issue 2.1 June 2006 819
Migration tasks
Perform the following tasks to convert a processor port network to a port network (CMC).
Note:
Note: If you want to make the system high reliability, you cannot reuse the Compact
Modular Cabinets (CMCs). You must install Avaya G650 Media Gateways and
move all the circuit packs to the G650s.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change or the system will not run.
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: Customers who currently use the Audix feature on the S8100 must purchase a
separate Audix system. The TN795 or the TN2314 Processor circuit pack that
contains the Audix feature is replaced with a TN2312BP Internet Protocol Server
Interface (IPSI) circuit pack that does not contain the Audix feature. You must
return the existing processor circuit pack to Avaya.
Note:
Note: Customers also must add an ED-1E568-70G1 DEFINITY Audix Slim board and a
TN2501AP Voice Announcement over LAN (VAL) circuit pack for
announcements.
Changing the control cabinet to a port network
To change the control cabinet to a port network, you must:
● Replace the TN795 or TN2314 Processor circuit pack with a TN2312BP Internal Protocol
Server Interface (IPSI) circuit pack.
● Connect a CAT5 straight-through cable from the IPSI to the media server through the
network of the customer.
To Next Page
Loading...
