Prerequisites
Issue 2.1 June 2006 91
Preupgrade service pack for upgrades starting from R2.x only
An upgrade from R2.x of Communication Manager requires a preupgrade service pack,
depending on which software load the media server is on. For more information about the
software load that is associated with each release, see Software release and load
on page 91.
!
CAUTION:
CAUTION: If the server has a Release 2.x field load other than those listed in the table, do
not use this section to upgrade the server. You must escalate.
Upgrading LSPs, ESSs, and H.248 media gateways, if any
Note:
Note: Do not perform these tasks and go to Accessing the media server maintenance
web interface on page 100 if the customer has none of the following network
elements:
- H.248 media gateways
- Enterprise Survivable Servers (ESSs)
- Local survivable processors (LSPs)
You must upgrade Communication Manager on the S8300 and S8500 LSPs before you
upgrade Communication Manager on the primary controller. If the configuration uses G250,
G350, or G700 Media Gateways, you must upgrade them to the latest firmware. If the media
server supports ESSs, you must upgrade the ESSs before you upgrade the primary controller.
Table 6: Software release and load
Software release of the
existing media server
Associated software load Service pack file name
2.0 R012x.00.0.219.0 00.0.219.0-xxxx.tar.gz
2.0.1 R012x.00.1.221.1 00.1.221.1-xxxx.tar.gz
2.1 R012x.01.0.411.7 01.0.411.7-xxxx.tar.gz
2.1.1 R012x.01.1.414.1 01.1.414.1-xxxx.tar.gz
2.2 R012x.02.0.111.4 02.0.111.4-xxxx.tar.gz
2.2.1 R012x.02.1.118.1 02.1.118.1-xxxx.tar.gz
To Next Page
Loading...
Need help?
General
