Introduction
Issue 2.1 June 2006 75
Upgrading Communication Manager from 1.x to 3.1
on an S8300 Media Server
Introduction
This module provides a high-level list of tasks that you must complete to upgrade Avaya
Communication Manager from a pre-2.1 release to a 3.1 release on an S8300 Media Server in
either primary controller or local survivable processor (LSP) mode.
Note:
Note: An upgrade to Communication Manager 2.1 or later requires an S8300B Media
Server. Replace the S8300A Media Server if it is in use.
To complete these tasks, you will need the following additional documents:
● Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server,
555-234-100, Issue 9, February 2006. To obtain this document, go to http://
support.avaya.com. Click S8300 > Installations, Migrations, Upgrades &
Configurations and then select the document.
● Administrator Guide for Avaya Communication Manager, 03-300509.
In this scenario, an S8300A that is configured as either a primary controller or an LSP and is
running Communication Manager pre-R2.1 release is replaced by an S8300B with a blank hard
drive.
For detailed procedures for most of the tasks in this upgrade scenario, see Installing and
Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server, 555-234-100,
Issue 9, February 2006.
To Next Page
Loading...
