Migrating a DEFINITY Server CSI in a CMC to an S8700-Series Media Server with IP-PNC
628 Upgrading, Migrating, and Converting Media Servers and Gateways
Migration tasks
The information in this section is based on the assumption that the media server complex is
installed, configured, and operational.
!
CAUTION:
CAUTION: This migration affects service. When the PPN is turned off, the system drops all
calls. Service returns when the media server takes control of the IPSIs.
The following list describes the general migration procedures:
● Turn off the processor gracefully - pre-conversion administration
● Replace the processor circuit pack or tone clock circuit pack with an IP Server Interface
(IPSI) circuit pack
● Connect the IPSI circuit pack to the Ethernet switch on the customer network
● Assign an IP address to the IPSI circuit pack
You can reuse the translations from the existing system when you migrate to an S8500 Media
Server.
Perform these tasks to convert a processor port network to a port network (CMC).
Premigration administration:
● Connecting to the media server on page 630
● Verifying system status on page 631
● Recording all busyouts on page 631
● Recording node names and IP addresses on page 631
● Saving translations on page 632
Installing and Configuring
an Avaya S8700-Series
Media Server (03-300145)
Provides installation instructions for the S8710 and
S8720 Media Servers.
Job Aid: Server and CSS
Separation - Avaya
S8700-Series Media Server
(555-245-766)
Provides information on and connectivity diagrams
when the S8710 or S8720 Media Servers are in
separate locations.
9
Document Description
To Next Page
Loading...
