Migrating a DEFINITY Server CSI in a CMC to an S8700-Series Media Server with IP-PNC
630 Upgrading, Migrating, and Converting Media Servers and Gateways
● Checking the link status on page 649
● Upgrading firmware on page 649
● Testing the installation on page 650
● Busying out previously busied out trunks on page 650
● Troubleshooting the migration on page 650
● Returning replaced equipment on page 650
Premigration administration
This migration is a service-affecting event. The CMCs must be turned off to replace the
processor and tone clock circuit packs. Before you turn off the cabinets, you must perform the
following premigration administration.
!
CAUTION:
CAUTION: The licensing of the platform and port network connectivity attributes for the
S8700-Series Media Server can be complex. See Caution about platform/PNC
license settings for the S8700-series Media Server on page 314 and License and
Avaya authentication files on page 313.
Connecting to the media server
To connect to the media server:
1. Connect one end of the green CAT5 straight-through cable to the Ethernet switch on the
customer network.
2. Connect the other end of the cable to the IPSI adapter on the back of the media gateway.
To Next Page
Loading...
