Premigration administration
Issue 2.1 June 2006 875
Upgrading firmware
Each IPSI must be on the most current and same firmware load. You might need to upgrade the
firmware on the IPSI. The most current firmware load is on the installation CD. To obtain the
firmware, you also can go to Avaya Support Web page(http://avaya.com/support
and click
Downloads.
First, verify the version of firmware that is currently on the IPSI circuit pack.
1. Under Installation and Upgrades, click View IPSI Version. Select Query All and click View
IPSI Version.
2. Verify the firmware release for the TN2312BP IPSI.
If necessary, upgrade the firmware on the just installed TN2313BP IP Server Interface circuit
pack that you just installed. For more information, see Upgrading firmware on the IPSIs and
SIPIs on page 283.
You also must upgrade the firmware on the following circuit packs, if necessary.
● UDS1 (TN464GP, TN2464BP, and TN2313AP)
● Maintenance/Test (TN771DP)
● Control LAN (CLAN) (TN799DP)
● IP Media Processor (TN2302AP)
For more information, see Upgrading firmware on the IPSIs and SIPIs
on page 283.
Upgrading software on the local survivable processors
For more information on the software upgrade process, see Installation and Upgrades for the
Avaya G700 Media Gateway and Avaya S8300 Media Server (555-234-100).
Note:
Note: Although the LSPs remain registered with the primary controller, the LSPs do not
accept translations if LSPs are running an older version of the software than the
software that is on the primary controller.
You can use the Upgrade Tool to upgrade the firmware on the G700 Media Gateway. For more
information on how to use the Upgrade Tool, see Job Aid: Upgrade Tool and Worksheets
(555-245-757).
You might be able to use the Upgrade Tool to upgrade the software on the S8300 Media Server,
depending on the version of the media server. For more information, see Installation and
Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Media Server (555-234-100).
To Next Page
Loading...
