Converting some or all direct-connect port networks to IP-connect
1062 Upgrading, Migrating, and Converting Media Servers and Gateways
g. Type 192.11.13.6 to access the IPSI, and log in again.
h. Enter show control interface.
The system displays the IP address, the subnet mask, and the default gateway
information.
Verify that the proper information was entered.
i. If a default gateway is used, type set control gateway gatewayaddr where
gatewayaddr is the customer-provided IP address for the network gateway.
j. Enter quit to save the changes and end the IPSI session.
k. Type 192.11.13.6 to access the IPSI, and log in again.
l. Enter show control interface to verify the administration.
m. Enter quit to end the IPSI session.
Setting the VLAN parameters and diffserv parameters
To set the VLAN parameters and diffserv parameters on the IPSI, if required:
1. Type telnet 192.11.13.6 to access the IPSI.
2. Enter show qos to display the quality of service values.
3. If necessary, use the following commands to set the VLAN parameters and the diffserv
parameters to the recommended values:
Note:
Note: Use Help to obtain syntax guidelines for these commands.
● Enter set vlan priority 6
● Enter set diffserv 46
● Enter set vlan tag on
● Enter set port negotiation 1 disable
● Enter set port duplex 1 full
● Enter set port speed 1 100
4. Enter show qos to check the administered values.
5. Enter quit to end the IPSI session.
!
Important:
Important: Ensure that the port settings on the Ethernet switches are set to the same values
as the values that appear in the set port commands.
To Next Page
Loading...
