On active S8710 Media Server
Issue 2.1 June 2006 879
2. Use a cross-connect cable to connect the laptop to the Services port (2) on the back of the
media server.
3. Wait at least 3 minutes after you turn on the media server before you start a Telnet session
to access the information on the CD-ROM.
Setting up a Telnet session
To set up a Telnet session:
Note:
Note: You might need a Telnet session to perform some of the tasks in this migration.
Note:
Note: Use a telnet session to access the information on the CD-ROM.
You can set the Microsoft Telnet application to send a carriage return (CR) and a line feed (LF)
whenever you press Enter. The installation program sees this as two key presses. If you are
running Windows 2000 or Windows XP, you must correct this before you copy the Remaster
Program to the hard disk.
1. Click Start > Run to open the Run dialog box.
2. Type telnet. Press Enter to open a Microsoft Telnet session.
3. Type display. Press Enter to see the current settings.
4. Perform one of the following actions:
If the system displays the message Sending only CR, close the dialog box.
If the system displays the message Sending both CR & LF, continue with step 5.
5. Type unset crlf. Press Enter.
6. Type display. Press Enter to verify that the settings changed. The system displays the
message Sending only CR.
7. Close the dialog box.
To Next Page
Loading...
