Upgrade tasks for the first media server
Issue 2.1 June 2006 221
Disconnecting from the active media server
If you are on site, unplug the laptop computer from the services port on the back of the active
media server.
Upgrade tasks for the first media server
Connecting to the standby media server
If you are on site, connect to the services port on the back of the standby media server.
If you are off site, log on to the standby media server with the actual IP address of the media
server.
Busying out the standby media server
To busy out the media server:
1. On the Maintenance Web page, under Server, select Busy-Out Server. Then click Busy
Out to busy out the standby server.
2. Click Status Summary to verify that the standby server is busied out.
Checking the software release on the media server, if starting
from R2.x only
Check the version of Communication Manager to ensure that you install the correct preupgrade
service pack. For more information, see Preupgrade service pack for upgrades starting from
R2.x only on page 201.
Under Server, click Software Version to see what software release is on the media server.
To Next Page
Loading...
