Converting some or all ATM port networks to IP-PNC
1138 Upgrading, Migrating, and Converting Media Servers and Gateways
Releasing alarm suppression (optional)
If you complete the upgrade well before the time set when you suppressed alarming, you might
want to release alarm suppression manually rather than wait for the system to release alarm
suppression.
To release alarm suppression:
1. Access the command line interface of the server with an SSH client like PuTTY and an IP
address of 192.11.13.6.
2. Log in as craft or dadmin.
3. Type almsuppress -n and press Enter to release alarm suppression.
4. Log off.
Logging off all administration applications
When you complete all the administration, log off all the applications that you used.
Configuration Diagrams
Figure 85: An S8700-series ATM fiber-PNC configuration with duplicated control networks on
page 1139 and Figure 86: An IP-PNC configuration with a duplicated control network that was
converted from ATM on page 1141 show before and after diagrams for the conversion of a ATM
system from a fiber-PNC configuration to a mixed fiber-PNC and IP-PNC configuration. The
IP-PNC configuration in Figure 85
was converted from an ATM configuration. Control network
duplication was retained for all port networks.
To Next Page
Loading...
