Migrating a DEFINITY Server CSI in a CMC to an S8700-Series Media Server with IP-PNC
640 Upgrading, Migrating, and Converting Media Servers and Gateways
Installing TN771 Maintenance/Test circuit pack
You must replace the TN798 or the TN2402 circuit pack with a TN771 Maintenance/Test circuit
pack. Each location must have one TN771 Maintenance/Test circuit pack.
To install the TN771 Maintenance/Test circuit pack:
● Install the TN771 circuit pack in slot 1.
This carrier does not have a dedicated slot for the TN775 Maintenance (EPN) circuit pack.
If the cabinet does not have a TN2302AP IP Media Processor (CSI did not require it), you must
install one in slot 10. For more information, see the Adding New Hardware book, Install and
Administer IP Connectivity Hardware section.
Connecting to the media server
To connect to the media server:
1. Connect one end of the green CAT5 straight-through cable to the Ethernet switch on the
customer network.
2. Connect the other end of the cable to the IPSI adapter on the back of the media gateway.
Post-migration administration
Accessing the server command line interface with SSH protocol
Note:
Note: Using the SSH protocol to access the server is applicable to CM Release 3.0 and
forward.
To use this procedure with a laptop cable connection to the services port, you must configure
your laptop for the network connection. See Network configuration
on page 1242. In addition, a
third-party SSH client must already be installed on your computer.
PuTTY is one such client available for download from http://www.putty.nl/download.html
. The
following procedure describes, as an example of SSH access, how to log into the server
command line with PuTTY.
To Next Page
Loading...
