Avaya S8100 Series - DEFINITY Server SI in an SCC; DEFINITY Server CSI or DEFINITY ONE;S8100 in a CMC; Avaya IP600;S8100 in a G600

Migrating hardware
Issue 2.1 June 2006 305
DEFINITY Server SI in an SCC
When you migrate an existing DEFINITY Server SI in an single carrier cabinet (SCC), you use
one TN2312BP IPSI circuit pack to control from one to three PNs. Avaya recommends that you
install the IPSI in the cabinet in the A position in the existing PPN instead of in one of the EPNs.
But before installing the IPSI, you must convert the PPN to a PN. This process requires that
you:
● Replace the processor control cabinet with an expansion control cabinet.
● Remove all the control circuit packs.
This migration affects service becuase you must turn off the PPN stack to replace the cabinet.
Before you turn off the cabinets, you must perform some premigration administration.
DEFINITY Server CSI or DEFINITY ONE/S8100 in a CMC
You can only migrate a DEFINITY Server CSI or a DEFINITY ONE/S8100 in a compact modular
cabinet (CMC) to an Avaya S8710 or an S8720 with an IP-PNC configuration.
When you migrate an existing DEFINITY Server CSI or a DEFINITY ONE in a CMC, you use
one TN2312BP IPSI circuit pack to control the PN. If a CSI, you replace the TN2182 Tone Clock
circuit pack with the IPSI which you install in the A position of the cabinet. You also must remove
the processor circuit pack. If a DEFINITY ONE, you replace the processor circuit pack with the
IPSI.
This migration affects service because, if a CSI, you must turn off the CMCs to replace the
processor and tone clock circuit packs. Before you turn off the cabinets, you must perform some
premigration administration.
Avaya IP600/S8100 in a G600
You can only migrate an Avaya IP600 to an Avaya S8710 or an S8720 with an IP-PNC
configuration.
When you migrate an existing Avaya IP600, you use one TN2312BP IPSI circuit pack to control
the PN. You replace the processor circuit pack with the IPSI in the cabinet in the A position.
This migration affects service becuase you must turn off the IP600 chassis to replace the
processor. Before you turn off the chassis, you must perform some premigration administration.