Migrating a DEFINITY Server R to an S8700-Series Media Server
764 Upgrading, Migrating, and Converting Media Servers and Gateways
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
Note: If the existing system has TN799C C-LAN circuit packs, you must replace these
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Saving translations
Although the migrated translations are already copied to the S8700-Series Media Server, this
step is important in case you need to back out of the migration.
Note:
Note: Save translations to disk, optical diskette, or tape.
To save translations, perform the following step:
1. Perform one of the following actions:
● To save translations to the hard disk on the DEFINITY Server R:
- For a single DEFINITY Server R, type save translation and press Enter.
- For a duplicated DEFINITY Server R, type save translation both and press
Enter.
● To save the translations to a magneto optical (MO) disk drive, type save translation
both removable and press Enter.
● To save the translations to a tape, type save translation tape and press Enter.
The system displays a Command successfully completed message or logs any error
messages.
To Next Page
Loading...
