304 Upgrading, Migrating, and Converting Media Servers and Gateways
The MOST tool that you use with the S8710 Media Server consists of:
● an external magneto optical drive
● a USB cable
Ordering information
!
CAUTION:
CAUTION: When you create the optical disk to move translations from the source system to
the S8700-Series Media Server, you must follow specific steps. For more
information, see Presite migration checklist
on page 311.
Migrating hardware
The information in this section is based on the assumption that the media server complex is
installed, configured, and operational.
DEFINITY Server SI in an MCC
When you migrate an existing DEFINITY Server SI in a multicarrier cabinet (MCC), you use one
TN2312BP IPSI circuit pack to control from one to three port networks (PNs). Avaya
recommends that you install the IPSI in the A carrier in the existing processor port network
(PPN) instead of in one of the expansion port networks (EPNs). But before installing the IPSI,
you must convert the PPN to a PN. This process requires that you:
● Replace the processor control carrier with an expansion control carrier.
● Remove all the control circuit packs.
This migration affects service because you must turn off the PPN to replace the carrier. Before
you turn off the cabinet, you must perform some premigration administration.
Comcode Description
700226269 Magneto Optical Server to S8700 Translations (not orderable)
700355415 Magneto Optical Server to S8710 Translations with USB cable
To Next Page
Loading...
