Migrating translations
Issue 2.1 June 2006 461
Adding IPSI translations to Communication Manager
To add IPSI translations to Communication Manager:
1. Type add ipserver-interface 1. Press Enter to add the IPSI circuit pack information.
2. If you use static addressing, in the Host field, type the IP address for the IPSI that is in the
port network listed in the Location field.
3. Verify that the IP Control? field is set to y.
4. Verify that all the other fields are populated.
5. Press Enter to put the changes into effect.
6. Repeat Steps 1 through 5 for each IPSI.
Setting the alarm activation level
To set the alarm activation level:
1. Type change system-parameters maintenance. Press Enter.
2. In the CPE Alarm Activation Level field, select warning, minor, or major, depending on
the level that the customer wants. The default is none.
Backing up translations
To back up translations:
1. Under Data Backup/Restore, click Backup Now.
2. Select the data sets and the backup method.
If you select Save ACP translations prior to backup, the media server automatically
saves the translations to the hard drive before the media server saves the translations to
the backup media.
3. Click Start Backup to begin the backup process.
To Next Page
Loading...
Need help?
General
