Converting software duplication link to a DAL1 link on an S8720 Media Server
1230 Upgrading, Migrating, and Converting Media Servers and Gateways
Replacing the cover on the server
To replace the cover on the server:
1. Place the top cover on the media server so that the front alignment tabs are in place (refer
to Figure 105: Remove the cover from the server
on page 1226.
2. Push the locking lever down.
The cover slides forward and locks into place.
Replacing the server in the rack
!
DANGER
:
DANGER: The Avaya S8720 Media Server weighs 20-27kg (47-60 pounds). Do not replace
the server in the rack by yourself.
To replace the server in the rack:
1. Ensure that the rails are extended and locked into place as shown in Figure 109
.
To Next Page
Loading...
