Migrating to an Avaya S8500 Media Server
446 Upgrading, Migrating, and Converting Media Servers and Gateways
Avaya IP600/S8100 in a G600
When you migrate an existing Avaya IP600, you use one TN2312BP IPSI circuit pack to control
the PN. You also must replace the processor circuit pack with the IPSI which you can install in
the A position of the cabinet.
This migration affects service because you must turn off the IP600 chassis to replace the
processor. Before you turn off the chassis, you must perform some premigration administration.
Prerequisites for migrating to an S8500 Media Server
This section describes the following tasks that you must complete before you start the
migration.
● Tasks that you must perform before you go on site
● Tasks that you must perform on site before you start the migration from an existing
DEFINITY system
● Tasks that you must perform on site before you start the migration
● Documents that Avaya recommends that you have before you start the migration
Migration modules
This chapter describes the following types of migrations:
● Migrating a DEFINITY Server CSI in a CMC to an S8500 Media Server on page 447
● Migrating a DEFINITY Server SI Direct-Connect in an SCC to a Direct-Connect on
page 477
● Migrating a DEFINITY Server SI Direct-Connect in an MCC to a Direct-Connect on
page 515
● Migrating a DEFINITY ONE/S8100 to an S8500 Media Server on page 547
● Migrating an Avaya IP600/S8100 to an S8500 Media Server on page 577
To Next Page
Loading...
