Basic migration steps
Issue 2.1 June 2006 833
Migrating an Avaya IP600/S8100 to an S8700-Series
Media Server with IP-PNC
Use these procedures to migrate from an existing Avaya IP600/S8100 IP-port network
connectivity (PNC) system to the Avaya S8700-Series Media Servers with an IP-PNC
configuration.
You can migrate an IP600/S8100 only to an Avaya S8710 or S8720 IP-PNC configuration.
When you migrate an existing Avaya IP600/S8100, you use one TN2312BP IPSI circuit pack to
control the port network (PN). You also replace the processor circuit pack with the IPSI in the
cabinet in the A position.
This migration affects service.
Basic migration steps
To migrate from DEFINITY platforms you must:
● Install the media server. If Avaya supplies an Ethernet switch and an uninterruptible power
supply (UPS), you also must install the switch and the UPS in the 19-inch rack. For more
information, see Quick Start for Hardware Installation: Avaya S8700-Series Media Servers
(555-245-703).
● Replace the tone clock circuit pack with the IPSI circuit pack
● Connect the media servers to the media gateways
● Enable control of the IPSIs and switch control to the media servers
● Complete the postmigration administration
Migration paths
DEFINITY IP600/S8100 and their releases that can be migrated to the S8710 or S8720 Media
Server IP-PNC configurations include:
● DEFINITY Release 9 through 10
● MultiVantage Release 1.1 and 1.2
● Communication Manager Release 1.0 through Release 1.3
To Next Page
Loading...
