Upgrade tasks for the new standby media server (second server)
Issue 2.1 June 2006 241
Verifying software operation
To verify the software version.
1. Under Server, click Software Version.
2. Look in the Reports as field to verify that the new software is present.
Checking system status
To check the system status:
1. Under Server, click Status Summary.
2. Verify the following information:
● Standby Refreshed is set to Yes
● Standby Shadowing is set to On
● Duplication Link is set to Up
Making the upgrade permanent on the media server
!
CAUTION:
CAUTION: You must make the upgrade permanent. Otherwise, the next time that you reboot
the media server, the server might come up running the previous version of
software. You might lose any new translations you might have made, and you
must install the new software again. If you do not make the upgrade permanent
within 2 hours of the upgrade, an alarm is raised.
To make the upgrade permanent.
1. Under Server Upgrades, click Make Upgrade Permanent.
2. Click Submit to make the partition with the new software version the permanent partition.
3. Under Server Upgrades, click Boot Partition to confirm that the new software release is
selected for the boot partition and the active partition.
To Next Page
Loading...
