Premigration administration
Issue 2.1 June 2006 365
● Verifying SIPI translations on page 379
● Verifying SIPI connectivity on page 380
● Verifying the customer data on page 380
● Verifying circuit pack locations on page 380
● Verifying circuit pack insertion on page 381
● Verifying the IP addresses on page 381
● Checking the link status on page 381
● Upgrading firmware on page 382
● Testing the installation on page 382
● Busying out previously busied out trunks on page 382
● Troubleshooting the migration on page 382
Premigration administration
This migration affects service because you must turn off the CMCs to replace the processor and
tone clock circuit packs. Before you turn off the cabinets, you must perform the following
premigration administration.
Connecting to the processor
To connect to the processor:
1. Connect the computer that you use to access the cabinet.
2. Start a SAT session using Native Configuration Manager or Avaya Site Administration.
3. Log in as craft.
To Next Page
Loading...
