Migrating from an S8700 Media Server to an S8710 Media Server
906 Upgrading, Migrating, and Converting Media Servers and Gateways
Busying out MMI circuit packs with SAT for a duplicated control
network only (main server only)
!
CAUTION:
CAUTION: Multimedia-to-voice station calls are not preserved on an upgrade. If you do not
busyout the TN787 Multimedia Interface (MMI) circuit packs, the TN787 and
TN787 Multimedia Voice Conditioner ports cannot be used.
To locate all the MMI circuit packs that need to be busied out:
1. Type display system-parameters customer-options. Press Enter.
2. Under the Multimedia Call Handling (MMCH) options, select Basic and Enhanced fields.
3. If either the Basic or Enhanced field is set to y, type list configuration all. Press
Enter to locate all MMI (TN787) circuit packs.
4. If MMI circuit packs exist, type busyout board UUCSS where UU is the cabinet, C is the
carrier, and SS is the slot.
5. Press Enter for each MMI circuit pack.
Checking for translation corruption
To check for translation corruption:
1. Type newterm. Press Enter.
2. If you see the following message:
Warning: Translation corruption detected . . .
then follow the normal escalation procedure for translation corruption before continuing the
upgrade.
Checking the software release
To check the software release:
1. Under Server Upgrades, click Software Version to see what software release is on the
media server.
2. Perform one of the following actions:
● If Communication Manager Release 1.0 or 1.1 software, upgrade the software to
Communication Manager Release 1.3.2.
● If Communication Manager Release 1.2 or 1.3 software, apply the upgrade patch.
To Next Page
Loading...
Need help?
General
