Postmigration administration
Issue 2.1 June 2006 465
Connecting to the media server
To connect to the media server:
1. Connect one end of the green CAT5 straight-through cable to the Ethernet switch on the
customer network.
2. Connect the other end of the cable to the IPSI adapter on the back of the media gateway.
Postmigration administration
Perform the following tasks to complete postmigration administration.
Accessing the server command line interface with SSH protocol
Note:
Note: Using the SSH protocol to access the server is applicable to CM Release 3.0 and
forward.
To use this procedure with a laptop cable connection to the services port, you must configure
your laptop for the network connection. See Network configuration
on page 1242. In addition, a
third-party SSH client must already be installed on your computer.
PuTTY is one such client available for download from http://www.putty.nl/download.html
. The
following procedure describes, as an example of SSH access, how to log into the server
command line with PuTTY.
Note:
Note: A version of PuTTY that is defaulted for SSH server access is available for Avaya
services personnel only. In this version, some values below have already been
pre-selected.
!
CAUTION:
CAUTION: While a variety of Avaya products support access using SSH, Avaya does not
provide support for third-party clients used for SSH access. Any problems with an
SSH client, including PuTTY, are the responsibility of the user or the SSH client
vendor.
To Next Page
Loading...
