Migrating from an S8700 or S8710 Media Server to an S8720 Media Server
978 Upgrading, Migrating, and Converting Media Servers and Gateways
2. Make the following selections:
● Select Immediate Shutdown
● Click Restart Server after Shutdown
3. Click Shutdown.
Removing the duplication cables
To remove the duplication cables:
1. Label and disconnect the duplication fiber cable from both S8700s or S8710s.
2. Label and disconnect the duplication interface IP cable from both S8700s or S8710s.
Removing the standby S8700 or S8710 Media Server from the rack
To remove the standby S8700 or S8710 Media Server from the rack:
1. Label and disconnect all remaining cables.
2. Disconnect the laptop from the Services port.
3. Disconnect the power cord from the UPS.
4. Remove the standby S87xx media server from the rack, if necessary.
5. Remove the rails from the rack.
Removing the DAL1 card, if necessary
Perform this procedure only if:
● Migrating from an S8710, and
● S8720 uses hardware-assist memory duplication, and
● Reusing the DAL1 from the S8710
To remove the DAL1 card:
1. Turn off the media server.
2. Extend the media server from the rack.
3. Lift up on the hood latch handle and remove the access panel.
Note:
Note: Always wear an antistatic wrist strap when working inside the media server.
To Next Page
Loading...
