Upgrading Communication Manager on Avaya S8500 Media Server or S8500 ESS Using Maintenance Web
98 Upgrading, Migrating, and Converting Media Servers and Gateways
3. Within this telnet session, type telnet IPaddress and press Enter, where IPaddress is
the IP address of the S8300/S8500 LSP or S8500/S8700-series ESS.
The login prompt for the LSP or ESS appears.
4. Log in to the LSP or ESS as craft.
5. Type stop -afcn and press Enter to stop potential call processing on the LSP or ESS.
The LSP or ESS shuts down Communication Manager.
6. Repeat steps 1
through 5 for each LSP or ESS.
!
CAUTION:
CAUTION: After you complete the upgrade of the primary controller, run save
translations on the primary controller before you restart Communication
Manager on the LSP./ESS The save translations process on the LSP or ESS
automatically causes the endpoints of the media gateways to reregister with the
primary controller.
For more information on the S8300 LSP, see Installing and Upgrading the Avaya G700 Media
Gateway and Avaya S8300 Media Server (555-234-100).
Starting a SAT session
To start a SAT session.
1. Open a terminal emulation application, such as MS HyperTerminal.
2. Type 192.11.13.6 5023 and press Enter.
3. Log on as craft or dadmin.
Note:
Note: You must use SAT commands for tasks in Checking link status with SAT (main
server only) on page 98 through Checking for translation corruption with the
SAT on page 100.
Checking link status with SAT (main server only)
To use the SAT to check the status of various links:
1. Type display communication-interface links and press Enter.
2. Note all administered links.
3. Type status link number and press Enter for each administered link.
To Next Page
Loading...
