Checklist for converting a port network to duplicated TN2602AP IP Media Resource 320 circuit packs
Issue 2.1 June 2006 1213
Upgrading firmware on the new TN2602AP circuit packs, if
necessary
If you determined that you must upgrade the firmware on newly-installed TN2602AP circuit
packs, if any, do so now. See Upgrading, Migrating, and Converting Media Servers and
Gateways (03-300412), "Chapter 4: Upgrading Firmware on TN Circuit Packs and Media
Modules."
Administering the node name for the TN2602AP circuit pack, if
necessary
Note:
Note: If you are replacing one or two TN2302 circuit packs, you can reuse the node
name and IP address for those circuit packs. Therefore, you may be able to skip
this task for one or both TN2602AP circuit packs.
To administer the node names for the circuit packs, perform the following steps:
1. Type change node-names ip and press Enter.
2. Type in the node names and IP addresses for the TN2602AP.
3. Type display circuit-packs and press Enter. Verify that the TN2602AP shows up in
the Code column.
4. Repeat steps 1 through 3 for the second circuit pack, if necessary.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
cognac 172.16 .19 .2 . . .
default 0 .0 .0 .0 . . .
medres03a01 192.168.1 .82 . . .
medpro02b04 192.168.1 .83 . . .
medpro02b05 172.16 .19 .222 . . .
clan03a04 192.168.1 .80 . . .
clan03a05 172.16 .19 .220 . . .
clan04b04 172.16 .19 .118 . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
( 12 of 12 administered node-names were displayed )
Use 'list node-names' command to see all the administered node-names
To Next Page
Loading...
