Upgrading firmware on the IPSIs and SIPIs
286 Upgrading, Migrating, and Converting Media Servers and Gateways
Upgrade tasks:
● Downloading firmware to IPSI on page 288
● Activating the new firmware on page 290
● Releasing standby IPSIs (duplicated control network only) on page 291
● Verifying the health of the IPSIs on page 291
Post-upgrade tasks:
● Verifying IPSI firmware version on page 292
Pre-Upgrade tasks
Access the Maintenance Web Interface
Access the Maintenance Web Interface with the following steps.
Note:
Note: If duplicated media servers, you must connect to the active media server.
1. If on site, connect to the services port, default 2 [Eth1], on the back of the media server.
If off site log in to the media server using the IP address of the media server.
2. Start the Web browser.
3. If connected directly to the media server, type 192.11.13.6 in the Address field to bring up
the logon Web page.
If connected through the network, type in the host name or IP address of the media server.
4. Log in as craft or dadmin.
5. When asked whether to suppress alarms, click yes.
6. Click Launch Maintenance Web Interface to get to the Main Menu.
Copying files to the media server
Copy the following files, as appropriate, from the computer to the media server:
● License and Avaya Authentication files
● Preupgrade and postupgrade service pack files
● Programmable circuit pack firmware
To Next Page
Loading...
