Migrating an Avaya IP600/S8100 to an S8500 Media Server
588 Upgrading, Migrating, and Converting Media Servers and Gateways
● Enabling control of the IPSI on page 606
● Verifying the customer data on page 606
● Verifying circuit pack locations on page 607
● Verifying circuit pack insertion on page 607
● Verifying the IP addresses on page 607
● Checking the link status on page 607
● Upgrading firmware on page 608
● Testing the installation on page 609
● Busying out previously busied out trunks on page 609
● Troubleshooting the migration on page 609
● Returning replaced equipment on page 609
Premigration administration
This migration affects service because you must turn off the IP600 chassis to replace the
processor. Before you turn off the chassis, you must perform the following premigration
administration.
Connecting to the processor
To connect to the processor:
Note:
Note: You need a cross-over cable to connect your Services laptop directly to the
processor.
1. Perform one of the following actions to connect the Services laptop directly into the Avaya
IP600 processor circuit pack:
● If the processor circuit pack is a TN795, place the NIC card into the slot on the faceplate.
● If the processor circuit pack is a TN2314, plug the RJ45 connector directly into the RJ45
jack on the faceplate.
2. Start a terminal emulation application or Avaya Site Administration.
3. Log in as lucent3.
To Next Page
Loading...
