Migrating a DEFINITY ONE/S8100 to an S8500 Media Server
574 Upgrading, Migrating, and Converting Media Servers and Gateways
Verifying circuit pack insertion
To verify circuit pack insertion:
1. To see the list of all the slot locations, type list configuration all. Press Enter.
2. Verify that the circuit pack code and vintage number appears in the Code and Vintage
fields. If No board appears in either field, a circuit pack was not installed in that slot.
Verifying the IP addresses
Ensure that the node names and IP addresses assigned to the TN2302AP IP Media Processor
circuit pack and the TN799DP C-LAN circuit pack are the same as before the migration.
To verify the IP addresses:
1. To get the node names for the TN2302AP IP Media Processor circuit pack and TN799DP
C-LAN circuit pack in the slots of interest, type display ip-interfaces. Press Enter.
2. To verify that the node names exist and that the IP addresses match the node names, type
list node-names. Press Enter.
Checking the link status
Compare the list that you made before the migration. Ensure that the in-service or the
out-of-service links match the status of the links before the migration.
To check the link status:
1. Type display communication-interface links. Press Enter.
2. Record all the enabled links.
3. Type status link number where number is a number 1-99. Press Enter.
4. Compare which links are in service with the premigration list.
5. Repeat steps 3 and 4 for all link numbers.
To Next Page
Loading...
Need help?
General
