Avaya S8100 Series - Connecting to the processor; Recording node names and IP addresses

Premigration administration
Issue 2.1 June 2006 847
Connecting to the processor
To connect to the processor:
Note:
Note: You need a cross-over cable to connect your Services laptop directly to the
processor.
1. Perform one of the following actions to connect the Services laptop directly into the Avaya
IP600 processor circuit pack:
● If the processor circuit pack is a TN795, place the NIC card into the slot on the faceplate.
● If the processor circuit pack is a TN2314, plug the RJ45 connector directly into the RJ45
jack on the faceplate.
2. Start a terminal emulation application or Avaya Site Administration.
3. Log in as lucent3.
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
Note: If the existing system has TN799C C-LAN circuit packs, you must replace these
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.