Migrating a DEFINITY Server CSI in a CMC to an S8500 Media Server
460 Upgrading, Migrating, and Converting Media Servers and Gateways
6. Click Restore Status.
7. Select the first file and then scroll down and click Review Status to see the results of the
restore.
When the restore process completes, the screen displays Restore is finished.
8. Use Native Configuration Manager or Avaya Site Administration to start a SAT session.
9. Type reset system 4. Press Enter to load the restored translations.
If the restore process fails, the system displays an error message that states the reason for the
failure. The translation file is not restored. You must resolve the reason for the failure and restart
the process.
Administering the IPSIs
To administer the IPSIs:
1. Type change system-parameters ipserver-interface. Press Enter
2. Verify that the Primary Control Subnet Address field is correct.
The subnet address must match the most significant three octets (the first three groups of
digits in the subnet address) of the server IP address that is listed on the control network
entry from the completed Electronic Preinstallation Worksheet (EPW).
An asterisk (*) to the right of the Subnet Address field means that although a subnet
address displays, this address is incorrect. Avaya Communication Manager does not have
the subnet information. After you verify the information shown on the screen, submit this
form with or without changes to update the Communication Manager with the correct subnet
information.
!
CAUTION:
CAUTION: If the information in the Primary Control Subnet Address field is incorrect, you
must change the information on the media server. Use the Maintenance Web
Interface. Under Server Configuration and Upgrades, click Configure Server to
change the media server configuration. Then continue with step 3 of this
procedure.
3. Verify that the Switch Identifier field is set correctly for this installation. You must enter the
correct switch identifier here before you administer the TN2312 IPSI circuit packs.
4. Verify that the IPSI Control of Port Networks field is set to disabled.
5. Press Enter.
To Next Page
Loading...
