Basic migration steps
Issue 2.1 June 2006 321
Migrating from a DEFINITY Server CSI in a CMC with
a Linear Flash
to an S8400 Media Server that uses a Card Reader
Use these procedures to migrate from an existing DEFINITY Server CSI in a Compact Modular
Cabinet (CMC) system or G600 Media Gateway with a linear flash to an Avaya S8400 Media
Server that uses a card reader.
To migrate an existing DEFINITY Server CSI in a CMC, you use one TN8412AP S8400 IP
Interface (SIPI) circuit pack to control the one port network. You must replace the TN2182 Tone
Clock circuit pack with a SIPI circuit pack that you install in the A position in the cabinet. You
also must remove the processor circuit pack.
This migration affects service.
Basic migration steps
● Remove the netcon data modules
● Replace the tone clock circuit pack with the TN8412AP S8400 IP Interface (SIPI) circuit
pack. For more information, see Quick Start for Hardware Migration: Avaya S8400 Media
Server in an Avaya CMC1 or G600 Media Gateway (03-300706).
● Replace the processor circuit pack with the TN8400AP Media Server circuit pack. For
more information, see Quick Start for Hardware Migration: Avaya S8400 Media Server in
an Avaya CMC1 or G600 Media Gateway (03-300706).
● Enable control of the SIPI and switch control to the media server
● Complete the postmigration administration
Migration paths
Avaya supports the following migrations of a DEFINITY Server CSI in a CMC or a G600 Media
Gateway to the S8400 Media Server configuration:
● DEFINITY Release 6 through Release 8
To Next Page
Loading...
