Overview
Issue 2.1 June 2006 1043
Regardless of the combination of PNC methods, the maximum number of PNs allowed is 64.
However, since a server can support IP-PNC and fiber-PNC PNs simultaneously, the following
capacity rules apply to a configuration with both IP-PNC and fiber-PNC PNs:
● With CSS, a configuration can include 2 to 44 CSS PNs, with an additional 20 IP-PNC PNs
● With ATM, a configuration can include 64 ATM and IP-PNC PNs in any combination
● With direct-connect, a configuration can include 2 or 3 direct-connect PNs, with 61 or 62
IP-PNC PNs
Note:
Note: When you convert a system to IP-PNC, the Internet Protocol (IP) PNC? field on
the Customer Options form the license file must be set to n. If this field is set to y,
you cannot mix fiber-PNC and IP-PNC PNs or use SCC1 or MCC1 cabinets in
the final configuration. If the final system is 100% IP-PNC and the configuration
does not include SCC1 or MCC1 cabinets, this field can be set to either y or n.
Avaya recommends n.
Media gateway combinations
The following table lists, by server, the media gateways and connection methods that you can
configure within a mixed IP-PNC and fiber-PNC configuration.
Table 21: Gateways supported in IP-PNC and fiber-PNC configurations
Server Supported
Central
Gateways
IP-PNC Direct-
connect
CSS/ATM-
connect
Reliabilities supported
S8500 CMC1 Yes No No Single control network and
single bearer network
G600 Yes No No Same as CMC1 with S8500
G650 Yes Yes No Same as CMC1
SCC1 Yes Yes No Same as CMC1
MCC1 Yes Yes No Same as CMC1
1 of 2
To Next Page
Loading...
