Preupgrade tasks
Issue 2.1 June 2006 133
2. Log in as craft.
3. Type almsuppress -t time, where time is the length of time that the alarms are
suppressed up to 120 minutes (2 hours). Press Enter to suppress both dial-out and SNMP
alarms.
The system displays the following message:
Alarm is suppressed. 120 minutes left.
4. Log off and close the dialog box.
Inserting the Communication Manager CD-ROM into the media
server
Insert the CD-ROM that contains Communication Manager into the CD-ROM drive on the media
server. Close the tray.
Note:
Note: You can copy Communication Manager software from an http or tftp server onto
the media server. In this case, skip this step.
!
CAUTION:
CAUTION: When you are upgrading the media server as a primary controller, you must
check Product Support Notice #739U for the supported upgrade paths. If you
attempt to upgrade the media server to a release that is not supported as an
upgrade path, you might corrupt the translations.
Also, you must check PSN #739U for compatibility of software loads between the
primary controller and any LSPs or ESSs. If the software loads of the primary
controller and the LSPs/ESSs are incompatible, then file synchronization
between the primary controller and the LSPs/ESSs can cause translation
corruption on the LSPs/ESSs.
To check PSN #739U, from any computer, access http://support.avaya.com.
Select Product Support Notices > View All Documents > PSN #739U.
To Next Page
Loading...
