Avaya S8100 Series - Assigning IP addresses to the IPSI circuit packs; Using static addressing

Postmigration administration
Issue 2.1 June 2006 467
Assigning IP addresses to the IPSI circuit packs
When you use static IP addressing, you must assign IP addresses to the IP server interface
circuit packs.
Using static addressing
You can administer static IP addresses for the IPSI circuit packs. You administer the addresses
directly through the Ethernet port connection on the IPSI faceplate switch which is the top port
(Figure 10: Connecting directly to the IPSI
on page 467).
Figure 10: Connecting directly to the IPSI
Note:
Note: Ensure that you have the IPSI password before you continue.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 cross-over cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4