Migrating from a DEFINITY Server CSI in a CMC to an S8400 Media Server using Xmodem
392 Upgrading, Migrating, and Converting Media Servers and Gateways
● Resetting the SIPI on page 407
● Enabling control of the SIPI on page 408
● Verifying SIPI translations on page 408
● Verifying SIPI connectivity on page 409
● Verifying the customer data on page 409
● Verifying circuit pack locations on page 409
● Verifying circuit pack insertion on page 410
● Verifying the IP addresses on page 410
● Checking the link status on page 410
● Upgrading firmware on page 411
● Testing the installation on page 411
● Busying out previously busied out trunks on page 411
● Troubleshooting the migration on page 412
● Returning replaced equipment on page 412
Premigration administration
This migration is a service-affecting event. The CMCs must be turned off to replace the
processor and tone clock circuit packs. Before you turn off the cabinets, you must perform the
following premigration administration.
Connecting to the processor
To connect to the processor:
1. Connect the computer that you use to access the cabinet.
2. Start a SAT session using Native Configuration Manager or Avaya Site Administration.
3. Log in as craft.
To Next Page
Loading...
