Migrating from an IP600 or S8100 to an S8400 Media Server using ftp
430 Upgrading, Migrating, and Converting Media Servers and Gateways
Migrating translations
This section provides information to migrate translation files from the current media server to
the S8400 Media Server.
Setting telnet parameters
The Microsoft telnet application can be set to send a carriage return (CR) and line feed (LF)
whenever you press Enter. The installation program interprets this as two key presses. You
need to correct this before you telnet to the server.
Note that this procedure is done entirely on your laptop, not on the S8400 Media Server.
To set the telnet parameters:
1. Click Start > Run to open the Run dialog box.
2. Type telnet. Press Enter to open a Microsoft Telnet session.
3. Type unset crlf. Press Enter.
4. Type display. Press Enter to confirm that Sending only CR is set.
5. Close the window by clicking the X in the upper-right corner.
This procedure resets your Microsoft telnet defaults and does not need to be done each
time you use Telnet.
Installing the software load
To install the software load:
1. From the Services laptop, click Start > Run to open the Run window.
2. Type ping -t 192.11.13.6. Press Enter to indicate when the Services port is
responding.
3. Click Start > Run to open the Run window.
4. Type telnet 192.11.13.6. Press Enter to telnet in to the Services port on the front of
the S8400 Media Server.
To Next Page
Loading...
