Basic migration steps
Issue 2.1 June 2006 355
Migrating from a DEFINITY Server CSI in a CMC with
an ATA Flash
to an S8400 Media Server
Use these procedures to migrate from an existing DEFINITY Server CSI in a Compact Modular
Cabinet (CMC) or G600 Media Gateway to an Avaya S8400 Media Server. Use the ATA flash
card on the TN2402 ProLogix Processor circuit pack for whichever loads that circuit pack
supports.
To migrate an existing DEFINITY Server CSI in a CMC, you use one TN8412AP S8400 IP
Interface (SIPI) circuit pack to control the one port network. You must replace the TN2182 Tone
Clock circuit pack with a SIPI circuit pack that you install in the A position in the cabinet. You
also must remove the processor circuit pack.
This migration affects service.
Basic migration steps
● Replace the tone clock circuit pack with the TN8412AP S8400 IP Interface (SIPI) circuit
pack. For more information, see Quick Start for Hardware Migration: Avaya S8400 Media
Server in an Avaya CMC1 or G600 Media Gateway (03-300706).
● Replace the processor circuit pack with the TN8400AP Media Server circuit pack. For
more information, see Quick Start for Hardware Migration: Avaya S8400 Media Server in
an Avaya CMC1 or G600 Media Gateway (03-300706).
● Enable control of the SIPI and switch control to the media server
● Complete the postmigration administration
To Next Page
Loading...
