Migrating a DEFINITY Server SI Direct-Connect in an SCC to a Direct-Connect
486 Upgrading, Migrating, and Converting Media Servers and Gateways
● Turning on the media gateway on page 502
Post-migration administration:
● Accessing the server command line interface with SSH protocol on page 502
● Using static addressing on page 504
● Clearing the ARP cache on the laptop computer on page 505
● Logging in to the IPSI on page 506
● Setting the control interface on page 506
● Setting the VLAN and diffserv parameters on page 508
● Resetting the IPSI on page 508
● Verifying IPSI translations on page 509
● Verifying IPSI connectivity on page 510
● Enabling control of the IPSI on page 510
● Verifying the customer data on page 510
● Verifying circuit pack locations on page 511
● Verifying circuit pack insertion on page 511
● Verifying the IP addresses on page 511
● Checking the link status on page 512
● Upgrading firmware on page 512
● Testing the installation on page 513
● Busying out previously busied out trunks on page 513
● Troubleshooting the migration on page 513
● Returning replaced equipment on page 513
Premigration administration
This migration affects service because you must turn off the PPN stack to replace the cabinet.
Before you turn off the cabinets, you must perform the following premigration administration.
!
CAUTION:
CAUTION: The licensing of the platform and port network connectivity attributes for the
S8700-Series Media Server can be complex. See Caution about platform/PNC
license settings for the S8700-series Media Server on page 314 and License and
Avaya authentication files on page 313.
To Next Page
Loading...
