Migrating a DEFINITY Server SI Direct-Connect in an MCC to a Direct-Connect
526 Upgrading, Migrating, and Converting Media Servers and Gateways
Connecting to the processor
To connect to the processor:
1. Connect the computer that you use to access the cabinet.
2. Start a SAT session using Native Configuration Manager or Avaya Site Administration.
3. Log in as craft.
Verifying system status
Check which groups are in- or out-of-service before the migration. After the migration, compare
the after the migration list with the before the migration list to ensure that the lists are the same.
To verify system status:
1. To determine whether the system has administration, run the following commands:
a. list configuration all
b. list trunk-group
c. list hunt-group
If any command does not complete successfully, escalate the problem immediately. After
the migration, check the same administration to ensure that the translations are intact.
Recording all busyouts
To record busyouts:
1. Type display errors. Press Enter.
2. Look for type 18 errors and record any trunks that are busied out. You can return these
trunks to the busyout state after the migration/upgrade.
To Next Page
Loading...
Need help?
General
