Migrating a DEFINITY Server SI in an MCC to an S8700-Series Media Server with Fiber-PNC
712 Upgrading, Migrating, and Converting Media Servers and Gateways
● Verifying IPSI translations on page 736
● Verifying IPSI connectivity on page 737
● Enabling control of the IPSI on page 737
● Verifying the customer data on page 738
● Verifying circuit pack locations on page 738
● Verifying circuit pack insertion on page 738
● Verifying the IP addresses on page 738
● Checking the link status on page 739
● Upgrading firmware on page 739
● Testing the installation on page 740
● Busying out previously busied out trunks on page 740
● Troubleshooting the migration on page 740
● Returning replaced equipment on page 740
Premigration administration
This migration affects service because you must turn off the PPN to replace the carrier. Before
you turn off the cabinet, you must perform the following premigration administration.
!
CAUTION:
CAUTION: The licensing of the platform and port network connectivity attributes for the
S8700-Series Media Server can be complex. See Caution about platform/PNC
license settings for the S8700-series Media Server on page 314 and License and
Avaya authentication files on page 313.
Connecting to the processor
To connect to the processor, perform the following steps:
1. Use the computer used to access the cabinet.
2. Start a SAT session with Avaya Site Administration.
3. Log in as craft.
To Next Page
Loading...
Need help?
General
