Upgrade tasks
Issue 2.1 June 2006 113
Installing postupgrade service pack, if any, on media server
Note:
Note: Do not perform this procedure if you are not installing a service pack for
Communication Manager.
This service pack might not preserve calls.
To install a post-upgrade service pack.
1. Access the command line interface of the server with an SSH client like PuTTY and an IP
address of 192.11.13.6.
2. Log in as craft.
3. Type update_unpack and press Enter.
4. Select the update by number and press Enter.
5. Type update_show and press Enter to list Communication Manager files to verify that the
new software update file was unpacked.
6. Type update_activate update, where update is the update ID number produced by
update_show. An example can be 00.0.628.x-xxxx. Do not use the .tar.gz extension at the
end of the file name. Press Enter.
The media server might reboot with an automatic reset system 4 command. If the
system reboots, it might also display the message
/opt/ecs/sbin/drestart 2 4 command failed.
Ignore this message. You must wait until the restart or the reset is complete before you
enter additional commands.
The media server displays a message that the service pack was applied.
7. Type update_show again and press Enter to list Communication Manager files to verify
that the new service pack file is activated.
Setting the Processor Ethernet
To verify the Ethernet port settings on the server and to set the processor Ethernet port.
1. Under Server Configuration, click Configure Server.
The Review Notices Web page appears.
2. Click Continue until the Specify how you want to use this wizard Web page appears.
To Next Page
Loading...
