Upgrade tasks (second media server)
Issue 2.1 June 2006 181
5. Click Submit.
6. Click Status to view the Backup History.
Note:
Note: The backup status function for the Linux Migration is not enabled for Release
1.3.1. To check the backup status when you upgrade from Release1.3.1, under
Data Backup/Restore, select Backup Status. Then select the backup set and
click Check Status.
7. Select the box next to the file that is being backed up and click Check Status. When the
backup is complete, the system displays the following message:
Backup is finished
!
Important:
Important: Check the text to verify that no error messages exist.
Erasing the MBR on the standby media server
To erase the master boot record (MBR):
1. Access the command line interface of the server with telnet and an IP address of
192.11.13.6.
2. Log in as craft or dadmin.
3. To erase the MBR, type sudo erase_mbr and press Enter.
4. When the system displays the message WARNING: Are you sure you want to erase the
master boot record? (y/n) [n] , type y for yes.
5. Type quit to end the telnet session.
To Next Page
Loading...
Need help?
General
